use Electrically heated steam generator Before the equipment, it is necessary to have a comprehensive understanding or training of the equipment, operate according to the operating instructions, and ensure that the mechanical equipment can operate normally.

Electric heating Steam generator usage method:

Before use, the water storage tank shall be inspected. There shall be no sundries in the water storage tank, or the water pump will be damaged or the check valve will be stuck.

Before operation, the steam safety valve must be opened, and then the blowdown valve must be opened until the water and dirt in the boiler are completely discharged.

install Electrically heated steam generator It is necessary to consider the influence of factors such as preventing the backflow of heated materials and the discharge of condensed water in the pipeline.

Close the blow down valve and the steam safety valve are still open. Turn on the main switch of the evaporator power supply, and a water shortage alarm will be sent at this time. The water valve will operate to make up water for the evaporator until the water level in the boiler is higher than the low water level, and then the alarm will end. When the water level reaches the high water level, the water pump will stop making up water.

The electric cabinet, water pump motor and other parts should be protected from moisture and water to avoid burning. The machinery and equipment shall be maintained regularly and kept clean.

When the evaporator enters the normal operation state, the steam safety valve can be closed, and the evaporator gradually increases pressure. When the steam pressure increases to the set pressure, the heating system automatically ends. At this time, steam can be used normally.

After the work is completed every day, cut off the power supply for 15 minutes, and drain when the pressure drops to 0.05Mpa. Pay attention to prevent scalding when draining.