We all know Electrically heated steam generator Before installation, it is necessary to check that all pipelines, instruments and interfaces are tight without looseness; Check that the electrical circuit is not damaged, the connector is not loose, and the power line interface is loose. And check whether there are other damages. In addition, it is also necessary to check whether all electrical connections performed on site are in exact accordance with the instructions in the circuit diagram.

Here are the necessary conditions for installation: general power line shall be selected according to heater power. Steam generator The water tank is built in, the water level is controlled by the float valve, and the water supply source must have a pressure of 0.1-0.15Mpa. Connect the soft water source to the water inlet of the water tank, and prohibit deep well water, river water and other non softened water. Note: Do not use distilled water, purified water and other media with low conductivity to affect the correctness of water level control detection; When air enters the water pump during primary use or use, please unscrew the water injection plug screw at the side of the water pump outlet, fill it with water, and then tighten the water injection plug. See daily maintenance and repair for details. Close the blow down valve and steam outlet valve.

There are also several points to note: please connect the safety valve outlet to the outdoor safety place, and the drain valve is fixed to the sewer. In addition, before using the equipment, please check whether the leakage protection function is normal. This product can only be opened after the above inspections are qualified.

So the above is about Electrically heated steam generator The operating steps and instructions of the controller are slightly different due to different models of steam generators and different controllers selected.