Boilers are widely used in almost every industry, such as chemical industry, washing, biomedicine, petroleum industry, paper mill, food factory, feed factory, and all industries that need steam or heat energy need boilers. With the progress of times and technology, as well as the impact of environmental protection pressure and energy-saving environment, many industries no longer use traditional boilers, Traditional boilers need to be reported for installation and annual inspection. They are special equipment with high energy consumption, high operating costs, excessive emissions, and high exhaust gas temperature, which will not save energy.

Ultra high energy consumption and load cost of traditional boilers. As the boiler is in single operation mode, it will be frequently started during operation, and a lot of heat will continue to disappear seriously. Second, the boiler is a large container, which stores a large amount of cold water. In the early stage, it needs to preheat the water to the boiling point, which wastes nearly an hour of energy consumption. In addition, the steam pipeline is too far away, which will lead to problems such as excessive heat loss in the furnace body, high exhaust gas temperature and low thermal efficiency. These are not economical for enterprises.

Full premixed low nitrogen Steam generator The gas outlet is fast, saving the pre preheating time and cost of the traditional boiler. Fully automatic control, no need for manual guard, saving wages. It is installed nearby without building boiler room, saving construction cost and pipeline heat loss.

Inspection exemption: the internal water volume is less than 30L water, so annual inspection is not required.   

Environmental protection: natural gas and liquefied gas can all reach the emission of low nitrogen below 30mg, meeting the emission standard.

Safety: no pressure vessel, internal 316L finned tube encircling heating, no explosion risk.

Full premixed low nitrogen steam generator Surface combustion technology refers to the premixing of gas and air before they enter the combustion chamber, so as to fully burn, improve combustion efficiency and reduce the release of harmful gases. It is a gas combustion technology at present.