Electrically heated steam generator It can continue the task or run on time without special personnel. The operator only needs to press the "ON" key to start the machine and the "OFF" key to shut down the machine. The temperature required for the heated materials in the heating equipment of the electric steam generator determines the task temperature of the electric steam generator. The temperature of the heat transfer oil is higher than the temperature of the heated data. The greater the temperature difference, the smaller the heating area required, and the greater the temperature difference. The temperature of heat transfer oil is high, and some chemical materials are easy to crack and coke under high temperature, so the size of the temperature difference should be determined according to the detailed situation, so as not to exceed the task temperature of heat transfer oil or damage the heating data. In order to avoid overheating and coking, the flow of heat conducting oil in the furnace tube should not be too low, and air preheater or energy-saving water heater should be installed at the tail to help the heating surface reduce the temperature of exhaust gas, thus improving the heating efficiency and wasting power. Electric steam generator is a thermal mechanical installation where heat energy is input into steam, low-temperature water or inorganic heat carrier with low external load and additional task fluid.

Manufacturer of electric heating steam generator Turn over the steam safety valve before operation, and then turn over the filter valve until the water and waste in the boiler are completely drained. Check the tank to ensure that there is no dirt in the tank, otherwise the centrifugal pump will be damaged or the one-way valve will be stuck. Close the filter valve, and the steam safety valve is still open. Turn on the main power switch of the air conditioner evaporator, at this time, the low water alarm will be recovered, the water inlet valve will operate, and the air conditioner evaporator will be replenished with water for moisturizing until the water level in the boiler is higher than the low water level. Stop replenishing water.

The electrical control cabinet and water pump shall be protected from moisture return, leakage and extinction. Mechanical equipment shall be kept at home on a regular basis and kept clean. When installing the steam generator pipeline, it is necessary to consider the factors such as preventing the backflow of heated materials and the discharge of pipeline condensate.