We know Small electric heating steam generator Due to its large gas storage space, the pure steam without water heat sharing efficiency reaches more than 97%, and the 99% pure steam quadruple safety assurance system recovers waste heat, saving electricity and energy. Electric heating is widely used because of its strong safety performance.

Electrically heated steam generator Installation of:

1. Try to install it in a place where the heat consumption is close and the operation and installation are convenient.

2. The hot water pipeline should not be too long, and should have a good insulation layer. The pipeline should be properly inclined from the hot steam output end to the end. The water supply source must be installed with a control valve.

3. The power supply must be equipped with supporting control switch, fuse and reliable protective grounding wire, 380v three-phase four wire extension (or three-phase five wire extension), 220v single-phase power supply, and the wiring standard shall be in accordance with the power line section standard in the attached table. All wiring must comply with relevant national regulations.

4. The power supply voltage must be controlled within 5%, otherwise the use effect will be affected. The 380v voltage must be three-phase five wire power supply, and the zero line cannot be connected incorrectly.

five Steam generator The ground wire of is related to the use safety, so a reliable ground wire should be installed. The grounding wire shall be driven nearby with a depth of ≥ 1.5m, and the ground wire cable connector shall be sintered on the ground wire pile head. In order to prevent rust and moisture, it is advisable to connect the joints 100mm above the ground.

6. When the water quality used does not meet the requirements, softened water should be used. It is strictly prohibited to use deep well water, water with many minerals and silt. Especially in northern sandy soil areas and mountain forest areas, attention should be paid to water quality.

7. Before starting the machine, check whether there is any abnormality in the power supply, voltage and water source, close the blowdown valve and open the water supply valve, and check whether the water pump is stuck. If the water pump is stuck, remove the rear cover of the fan blade, and rotate the motor shaft to a flexible state to start the machine.

8. After starting the machine, observe whether there is any abnormality in the working process of the machine. If there is any abnormality, refer to the fault handling method, and then start the machine for use after troubleshooting.

9. After the shutdown, the power switch must be turned off. When the pressure is reduced to 0.1MPa, the sewage shall be discharged. At the same time, the water inlet valve shall be closed.

After reading this article, I believe that we should pay more attention to small electric heating Steam generator equipment There are different views. If you want to know more about steam generator, please leave a message!