Henan steam generator manufacturer Indicates the newly used Steam generator When water cannot enter, install the air exhaust screw, close the blow down valve and the steam outlet ball valve, close the case, connect the tap water, and turn on the power switch. At this time, the machine interior has been powered on, and then the working switch is turned on, the water pump indicator light is on, and the water pump starts to fill the tank. When the tank water reaches the specified capacity, the heating indicator light is on, and the electric heating tube starts to heat to generate steam, and the pressure continues to rise. When the water level in the tank is close to the upper limit, the high water level indicator lights up and the water pump stops filling. When the steam pressure reaches the set value, the machine will automatically stop.

There are many reasons why the steam generator can not feed water, such as air in the water pump of the operating device, pipeline blockage, water source interruption, etc. In order to suit the remedy to the case, we need to check and analyze the faults and eliminate them one by one until the cause is found.

When the steam generator cannot automatically feed water due to idle operation due to air in the water pump of the operating device, we need to exhaust air from the feed pump, and the specific operations are as follows:; If the equipment is used for a long time, and the sewage is not cleaned in time, and the water quality is too poor, which causes the scale to form and block the pipe or pipe mouth, in this case, only the pipe can be dredged to solve the problem of water feeding into the steam generator; For the interruption of water source, it is enough to supply water source in time. It must be noted that water supply cannot be interrupted during the use of steam generator.

Henan Steam generator manufacturer It means that if the steam boiler produces scale due to excessive scale, the heating area of the boiler will be affected, and a large amount of water will be trapped in the steam. It is necessary to equip softened water equipment to reduce scale generation and extend boiler life. Check whether the water level in the water tank of the steam generator gets hot. If it gets hot, it should be that there is something wrong with the check valve. After the check valve is removed, it can be flushed with clean water and then water can be added normally. Check the water level to see if it is out of order. The water level probe can be removed to clean the dirt on the probe with sandpaper, and the scale in the water level cylinder can be cleaned with a wire bucket. Clean up the water path leading into the boiler tank. If the water path is unobstructed, the water level probe cannot be inserted with sandpaper. It needs to be replaced with a new water level probe.